Tag Archives: lampshade makeover

Square lampshade redo

In my quest to finish my little man’s big boy room, I decided to add a few more projects to the list.  One was a new lamp that was more fitting with the rest of the room.  This idea started when I saw this lamp shade at a thrift store for $3 and a recollection of the 20,000  tutorials to recover a lampshade. Interestingly I never found a tutorial for a square lampshade, so here’s my stab at it!

While I pulled some ideas from a few of them, I followed the tutorial from shanty 2 chic the most.

I started by cutting down a seam and then carefully removing the outside layer of fabric (Keep the liner on). Try to keep the fabric all in one piece as that will be your template for your new fabric.  Good thing I read the tutorial before attempting this, because I’m totally that girl who just rips everything apart and then tries to figure it out later.  You’ll end up with just the lampshade skeleton

Because my lampshade was square, and my fabric didn’t have much give to it.  I ended up cutting 4 pieces and sewing the edges together.  This was different from all the other tutorials I had seen. I added 1/2″ of extra fabric all around my previous fabric template before cutting it out. Then just ran a stitch connecting all 4 sides. I trimmed the excess fabric off about a 1/4″ from the seam to make it less bulky and allow it to look more smooth.

Place the new fabric over your lampshade skeleton. (sorry for the bad lighting.  Some project are done best at midnight!)

I used my cameo to add an acrylic barn red-painted stencil of the number “10” to coordinate with my little man’s decor and vintage car theme. I was afraid that it would have been too hard to paint this once the fabric was on the lampshade, so I chose to do it before.  I don’t know if I would bother doing it that way again.

I placed the new lampshade over the skeleton.  Using E-6000 and clothespins I stretched the fabric, glued with e-6000 and held in place with clothespins.  Oh I should mention that I cut all the corners at a diagonal (essentially cutting the bottom corner off) to make the fold over and gluing much easier and again to make sure it laid smoothly on the lamp shade.  I clipped the top of one side with clothespins to hold it in place, then glued and clipped the bottom.  I did each side then waited a few minutes before moving to the next side.  I did all 4 sides on the bottom of the lamp shade before tackling the top.

To finish it off I added my own DIY bias tape to the top and bottom of the shade using excess fabric cut into strips long enough to wrap around the bottom and top of your shade.  Fold over a side and iron, then fold over the other side iron.  Wrap around the bottom of the shade and use e-6000 to glue on.

This little project inspired me to make my own lamp, and night stand too.  Stay tuned, you might even see little man’s vintage care themed bedroom reveal yet this summer?!

Advertisements

1 Comment

Filed under Before/After, DIY Projects, Gift of Thrift, Tutorials